Fresh Group Consulting

When a supplier specification changes, does your shelf-life evidence still apply?

Two food quality technicians review paperwork beside a container of ingredients at a receiving station.

A supplier widens the pH range on a chilled ingredient specification. The ingredient code stays the same and purchasing has already raised the next order. Before goods-in releases the delivery, QA needs to establish which lots fall under the revised specification and whether the finished product’s shelf-life evidence covers them.

Find the first affected lot

Ask the supplier for the old and new specifications, the reason for the change and the first lot or production date affected. Confirm whether both versions can arrive under the same item code. Give goods-in a way to identify the revised lots and hold them pending technical approval. If stock has already been used, trace the affected ingredient lots into finished batches and establish their distribution status.

Test the change against the finished product

Take a hypothetical chilled, ready-to-eat bean salad sold in the EU. Its supplier widens the allowable pH range for a dressing used after the beans are cooked. Map the new range against the formulation and the finished-product conditions covered by the shelf-life study. Check whether the study covers the highest plausible finished-product pH, including variation between batches and between components where relevant. Review other assumptions that could affect growth, including water activity, storage temperature and shelf life. If the revised ingredient can take the salad outside the evidence reviewed, keep affected stock on hold and establish what additional assessment or validation is needed before release.

Check the EU criterion

Article 5 of Regulation (EC) No 852/2004 requires food business operators to review their HACCP-based procedures when the product, process or any step changes and make necessary changes. Regulation (EC) No 2073/2005 requires shelf-life studies as necessary. Since 1 July 2026, under Commission Regulation (EU) 2024/2895, the Listeria monocytogenes criterion for ready-to-eat foods that support growth, excluding foods intended for infants or for special medical purposes, applies while products are on the market during their shelf life. The criterion is absence in 25 g if the producing operator cannot demonstrate to the competent authority’s satisfaction that levels will stay at or below 100 cfu/g throughout shelf life. Where that demonstration is made, the 100 cfu/g criterion applies. These are EU legal requirements. The workflow in this article is a practical way to review a change.

Make the decision usable at goods-in

Record the affected lots and finished products, the evidence reviewed, the disposition and who authorised it. Give purchasing and goods-in the approved specification revision, the first acceptable lot and any extra intake checks. If a concession or additional check has an expiry date, assign someone to close it. At the next delivery, verify that the lot on the pallet matches the revision in the decision record.

Try it with an open purchase order

Pick a chilled ingredient used in more than one ready-to-eat product. Ask a buyer, a goods-in operator and a QA lead to identify the first affected lot from a sample change notice. Then ask QA to show what finished-product evidence covers that lot. If any handover depends on someone spotting an email, add the revision and lot boundary to the intake instruction.

Primary sources

Regulation (EC) No 852/2004
Regulation (EC) No 2073/2005, consolidated from 1 July 2026
Commission Regulation (EU) 2024/2895

Leave a Reply

Your email address will not be published. Required fields are marked *