
The trailer is cold when it reaches the dock, but the logger shows a warming period in transit. The receiving team needs two decisions. Where can the load be stored safely while it is assessed, and who can authorise its release? Build both decisions into the receiving procedure before the next alarm.
What the US rule requires
Under 21 CFR 1.908(a)(6), when a covered shipper, loader, receiver or carrier learns of a possible material temperature-control failure or another transport condition that could make food unsafe, the food must stay out of sale and distribution. The parties must take appropriate action, including communicating as needed, unless a qualified individual determines that the deviation or condition did not make the food unsafe. This is an existing federal requirement. FDA’s rule overview explains the scope, exceptions and waivers for covered US road and rail operations.
1. Put the affected stock on hold
At the dock, identify the shipment and affected lots, block them from allocation in the warehouse system and alert QA, the shipper and the carrier as appropriate. If the load is unloaded, keep it under suitable temperature control in a designated hold location. Record where it went and who controls the hold. If any pallets have already moved, establish their location immediately and use the site’s escalation procedure.
2. Reconstruct the journey
Export the original logger data before the device is reset. Record its position, time zone and calibration status. Ask the carrier for the refrigeration unit’s records and any stops, door openings or alarms. Compare those times with loading and arrival records, and obtain representative product temperatures using the site’s approved method. A trailer set point describes the unit’s target. A cold product reading at arrival describes that sample at that moment. The qualified individual needs evidence that accounts for the period in between.
3. Make a product-specific decision
Give the qualified individual the product and lot details, the shipper’s written transport specification where applicable, the best-supported temperature history and its gaps, and the relevant food safety evidence. For a chilled ready-to-eat product, that assessment may consider the hazards identified for the product, its formulation, packaging and remaining shelf life. Document the evidence, the affected lots, the disposition, the rationale and the decision-maker. Keep the hold in place while the evidence is insufficient to support a safety determination. Resolve any separate customer specification or quality issue before routine release.
Worked example: a gap in the logger record
A load of chilled ready-to-eat hummus arrives with a warm-air alarm and a gap in the logger file. The sampled packs are cold at receipt. The carrier’s records show when the refrigeration unit restarted, but the records do not establish the product’s exposure before the restart. QA keeps the implicated lots blocked and asks for the original logger export, sensor locations and loading records. If those records and the product-specific evidence still leave a safety-critical gap, escalate for documented disposition under the site procedure and keep the stock out of distribution.
Test the handover on the next shift
Give the receiving team a sample alarm and ask them to show which stock they would block, how they would recover the data and whom they would call after hours. Ask the qualified decision-maker what evidence would change the disposition. Capture the answers on a single hold record that the next shift can use without reconstructing the incident from emails.
Sources
21 CFR § 1.908, transportation operations